German Romana
Hydraulic control unit with pressure block    
     
JD 40 / 60 / 80
JPE 30 - VS
JPE30-VS
 JD 40



JD 60



JD 80
 JD 40
JD 60
JD 80
 
Problem?
Solution!
Problem
Lösung
JPE 30-VS + JD-Serie + JH-Serie

  • Contact points under load vary
  • Load with uneven weight - distribution balance

  • Extend the jacks individually through central control unit until the lift toes apply the same pressure to the load
  • Keep the load level when lifting and lowering by adding a pressure block to the oil circuit

More information and a detailed solution for your lifting problems are available on request.
   
  Examples  
Mobile Hubanlage für Kettenfahrzeuge
Mobile lifting unit for tanks:

This unit was built for a german army maintenance centre and is able to lift a load of 45 tonnes/99,000 lbs. Synchronised, lifting is done through 4 tandem lifting units with a stroke of 400 mm and a lowered height of 420 mm. Due to the asymmetric centre of gravity position the lifting units are connected with a pressure block which allows a simultaneous and synchronised lifting of the load. The necessary pressure is produced by an electrical pump. This solution and of course all other special solutions could be adapted exactly to the demands of the customer.		  
Synchronised lifting unit for loads up to 80 tonnes:

This machinery was developed for a specific lifting problem, also with an unevenly distributed load on the lifting points. The jacks are specially designed with a stroke of 250 mm. The total load capacity of the equipment is 80 tonnes/176000 lbs. It is possible to control the use of the jacks in each step from a central secure position through the control unit on the top of the hydraulic pump and beneath the pressure block. All components together with the jacks were fitted on an individual transport trolley for easy transportation.
Synchronhubanlage
  Imprint | © 2006 JUNG Hebe- und Transporttechnik GmbH